PLANET NAS-7450 - Manual (Page 13)

13
5. After you edit the last digit of the IP address, press the right button and
configure the Subnet Mask address.
6. Repeat Steps 4 to Steps 5 to configure the Subnet Mask and Gateway
address.
7. After you edit the last digit of the Gateway address, press the right button.
Move the cursor to Save and save the setting or Edit to repeat the above
process or Abort to quit the configuration process without saving.
8. Repeat the above process to configure the other LAN port.
Configuring the IP addresses using NAS Finder
You can use the provided utility PLANET NAS Finder to perform the initial setup
of your newly arrived NAS server. The utility designed to perform a quick set up
and put your NAS server online in just a few minutes. During startup, NAS Finder
begins to discover the entire NAS server on the network. The default server name
would be “NASxxxxxxxx”, where “xxxxxxxx” is the last eight digits of the Ethernet
address of LAN1.