PLANET NAS-7450 - Manual (Page 12)

12
Configuring the IP addresses using the LCD console
1. After NAS server is boot up, the LCD console shows System Ready. Press the
right button.
2. The IP address of LAN1 is shown. Press the middle button to configure LAN1 IP
address. Note that the

symbol at the right hand upper corner indicates that
the IP address can be configured using the LCD console.
3. Move the cursor to “Yes” by pressing the left button and then press the middle
button to confirm.
4. Move the cursor to the correct position using the left or right button. Then press
the middle button to change that number.