PLANET IKVM-8000 - Manual (Page 16)

3
Chapter 3
Initial Configuration
3.1 Default Settings
The communication interfaces of IKVM-8000 are all based on TCP/IP. It comes
with the default settings as below.
Parameter Value
IP auto configuration
DHCP
IP-Address 192.168.1.1 (disabled)
Net-mask 255.255.255.0
Default-Gateway none
Super user name super
Super user password pass
3.2 Configuration via Setup Utility
By default, the IKVM-8000 will obtain its IP address from a DHCP server in the
network. If a DHCP server is found, it may provide a valid IP address, gateway
address and net mask. Before you connect IKVM-8000 to your local network,
please make sure the corresponding configuration of your DHCP server is com-
pleted. It is recommended to reserve a fixed IP assignment to the MAC address of
the IKVM-8000. You can find the MAC address labeled on the bottom side of the
metal housing.
If this initial configuration does not meet your local requirements, use the setup tool
to adjust the values to your needs. The setup tool can be found on the CD-ROM
delivered with this package. You can follow the procedure described below.
1. Connect the IKVM-8000 to the same network as your administrative PC, or you
can use an USB cable (type A to type B) to connect administrative PC and
IKVM-8000 directly. The USB connectivity only supported in windows 2000/XP
and server 2003 and the response time of USB connection would be longer than
LAN connection.
11