PLANET IKVM-8000 - Manual (Page 12)

7-Segment BANK LED Indication
If you want to view the next bank KVM switch, please press “ BANK
“ push button cyclically to the destination bank. The bank LED will be
changed from bank 1 to the maximum daisy chain level and then to press
“ BANK “ push button once back to the bank 1.
Bank 1 Bank 2 Bank 3 MAX. BANK
Reset Button: ((“ ” button) and (“ ” button)):
To press both “Bank” button and “PC8” button of master IKVM-8000 simulta-
neously can reset KVM switch. This reset action will not only return KVM
switch back to initial state --- Check the password, but also re-check all of
slave banks which connected to mast KVM Switch.
If you add a new KVM Switch as a slave bank, please use reset button of
master KVM Switch to automatically assign a new ID to it. You can view this
new slave bank through OSD menu.
Hot Key Commands:
You can also conveniently switch ports through simple key sequences. To
send commands to KVM switch, the “SCROLL LOCK” key must be
pressed twice within 2 seconds. You will hear a beep for confirmation and
the keyboard is in hot key mode. If you have not pressed any key in hot key
mode within 2 seconds (It means to key in any key follows up “Scroll Lock”
“Scroll Lock” key ), the keyboard will back to Operation System (O.S.) control
state.
Below are the different hot key commands (for local KVM):
Note: You also could press “up arrow key” or “down arrow key” longer time to
speed up or speed down selecting the destination port.
7