PLANET FPS-3300 - Manual (Page 43)

7. Network Print Monitor
The print server supports TCP/IP, IPX/SPX and NetBEUI protocols under Windows 95/98/Me. Please make
sure that the following steps have been completed before proceeding with installation under Windows PC.
Select A Desired Protocol
TCP/IP
The TCP/IP Protocol must be installed. For further information, please read “TCP/IP Protocol Installation”
section in this chapter.
Note: If TCP/IP protocol is chosen, please refer to “Assigning an IP Address to the print server” section later in
this chapter.
IPX/SPX
The IPX/SPX-compatible Protocol must be installed. For further information, please read “IPX/SPX-compatible
Protocol Installation” section in this chapter.
NetBEUI
The NetBEUI protocol must be installed. For further information, please read “NetBEUI Protocol Installation”
section in this chapter.
7.1 TCP/IP Protocol Installation
1. Click Start, point to Settings and select Control Panel.
2. Double click the Network icon.
3. If
the TCP/IP Protocol is not already installed, click Add.
4. Select
Protocol and click Add.
5. Select
Microsoft from the Manufacturers list.
6. Select
TCP/IP Protocol from the Network Protocols list.
7.
Specify an IP address, Subnet Mask, and Gateway address or specific “Obtain IP address automatically”,
if a DHCP server is available on the LAN.
8.
Restart the computer.
9. Done.
Note: Using TCP/IP protocol to access the print server requires well-configured TCP/IP settings. If you are not
familiar with these settings, please consult your network administrator for details or ask for help.
43