PLANET FRT-401 - Manual (Page 46)

46
Basic Settings
MAC/IP/Port Filtering:
Enable or disable the MAC/IP/Port filtering function.
Default Policy:
The Packet that does not match any rules would be dropped or
accepted.
MAC/IP/Port Filter Settings
MAC Address: Enter the MAC address that matches the source address of the
packet (optional).
Dest IP Address:
Enter the IP address that matches the destination address of the
packet (optional).
Source IP Address:
Enter the IP address that matches the source address of the
packet (optional).
Protocol: There are 4 options, including none, TCP, UDP and ICMP.
Dest Port Range: After setting a valid protocol, you may enter the UPD or TCP
destination port range.
Source Port Range:
After setting a valid protocol, you may enter the UPD or TCP
source port range.
Action:
Select Drop or Accept in the drop down list.
Comment:
Add description for this rule.
Click Apply to make the configuration take effect. Click Reset to cancel the new
configuration.
The maximal rule number you can add is 32.
Current MAC/IP/Port filtering rules in system
If you want to delete some rules in the table above, select the rules, and then click Delete
Selected . Otherwise, click Reset.