PLANET BM-2101 - Manual (Page 90)

Authentication
Authentication Management
„ It can provide the authentication port to the MIS engineer and the valid
authentication time . (The MIS engineer has to set the Authentication function
first .)
‹ Authentication Port When enable the Authentication, the LAN user must
pass the authentication to login to the WAN. And the authentication port
number is the default value of 82 .
‹ Re-Login if IdleWhen the LAN user connect to the WAN , the MIS
engineer can set the Idle time after the Authentication. When the login Idle
time has over the default Idle time settings of 30 minutes . The authenticaion
will automatically invalid .
‹ Re-Login after user login successfullyWhen the LAN user connect to the
WAN through the authentication . The available authentication time depends
on the time limit , if over the default time setting , the authentication will be
invalid .
‹ Disallow Re-Login if the auth user has loginWhen enable this function
through User ,User Group , RADIUS , POP3 or LDAP to access the
authenticaion , the authorized account can not be used by other people .
‹ URL to redirect when authentication succeedTo direct the authorized
LAN user to the assigned web site . The default value is blank . It will
directly link the user to the login web site .
‹ Messages to display when user loginIt shows the login messages in the
authentication window ( it supports the HTML ) , the default setting is blank
it will not show any massage in the authenication window.