PLANET BM-2101 - Manual (Page 186)

Chapter 13
P P o o l l i i c c y y
The BM-2101 can detect every packet pass by the devices , and to valuate if the
packets can fit the policy. When the packets can qualified by the policy , the BM-2101
will allow the packets to go through the policy. In other words , if the packets can not fit
the policy , then it will be blocked .
The policy parameter included the source address , destination address , service ,
schedule , authenticatoin user , VPN trunk , action, WAN port , traffic log , statistics ,
IDP , content blocking , anti-virus , Qos , MAX.concurrent sessions , quota per session
and quota per day . The MIS engineer can use these parameters to set the outgoing and
incoming service in data transmission by policy management.
How to use the Policy ?
The BM-2101 can divide the Policy into 6 function depends on the data packets in
different source address . The MIS engineer can easy to set the policy of source IP ,
source port , destination IP and destination port by data packets .
1. Outgoing The source IP is in LAN and the destination IP is in WAN .The MIS
engineer can set the outgoing policy included the network packets and
services .
2. Incoming The source IP is in WAN and the destination IP is in LAN ( For
example , the IP mapped and virtual server ) . The MIS engineer can set the
incoming policy included the network packets and services.
3. WAN To DMZ The source IP is in WAN and the destination IP is in DMZ (For
example , the IP mapped and virtul server ) .The MIS engineer can set the
WAN To DMZ policy included the network packets and services .