PLANET BM-2101 - Manual (Page 31)

Can enter the interface IP of WAN 1 WAN 2 by Assist.
After completed the settings, there are two LAN segment 192.168.1.0/24 (the default LAN segment)
and 162.172.50.0/24. Therefore, if the LAN IP is:
„
192.168.1.xx –Use the NAT Mode to connect to the network (As regulated in Policy, one can only
connect to network via WAN2. If use Routing mode via WAN 1, an virtual IP can’t be usd to
connect to network).
„
162.172.50.xx—WAN 1: Routing mode (MIS engineer IP 162.172.50.xx can be seen by the
internet server ) ; WAN2: NAT mode (The IP seen by the internet server is WAN2’s IP)