PLANET ICA-2250VT - Manual (Page 17)

Industrial PoE Plus Outdoor IR IP Camera
ICA-2250VT
17
2.2.6. Network Installation
1. Connect an Ethernet cable
Connect the LAN cable on the camera to the network device (hub or switch).
If there is an IEEE802.3at PoE switch in your network, you can connect the camera
LAN cable to this PoE switch to obtain power. The power adapter is unnecessary when
Internet camera is connected to a PoE switch.
2. Attach the power supply
Plug in power adapter and connect to power source. After power on, the camera will start to
operate.
1. Only use the power adapter supplied with Internet camera; otherwise, the product
may be damaged.
2. The power adapter is unnecessary when Internet camera is connected to a PoE
switch. Otherwise, the product may be damaged when Internet camera is
connected to a POE switch and power adapter simultaneously.
3. Attach BNC connector
Connect the video BNC connector to a monitor set, if necessary, to check camera viewing
angle and focus.
4. Attach Speaker to camera (optional)
If user needs both video stream and audio stream, then the speaker should be attached to
camera.
5. PoE (Power over Ethernet)
Power over Ethernet (PoE) is a technology that integrates power into a standard LAN
infrastructure. It enables power to be provided to the network device, such as an IP phone or
a network camera, using the same cable as that used for network connection. It eliminates
the need for power outlets at the camera locations and enables easier application of
uninterruptible power supplies (UPS) to ensure 24 hours a day, 7 days a week operation. The
IP Camera requires a connectivity to IEEE802.3at Power over Ethernet Switch (PSE) or
802.3at Injector for the system includes camera itself, infrared LEDs, internal blower, and
heater.