PLANET HDVR-1600 - Manual (Page 63)

7.10 HCMS Motion Detection
Users can setup motion detection at HCMS site individually. Right
click on a desired grid and select from the pull
down menu. The motion detection setting window is shown as
below.
Users can choose to monitor the complete screen or select up to 8
boxed areas after clicked on . Click on button
to delete all selected areas. Alternatively, right click on any
selected area to delete it individually.
Enable Function: Check on it to start monitor motion detection.
Motion recording : Check on it and the HCMS will record event video when motion is detected. The
length of event video will follow specified in Event setting.
Start Simulation: Click on it to start simulating motion detection. As shown above, red boxes will
mark the motion areas.
Stop Simulation: Click on it to stop simulation.
Sensitivity: Setup a desired sensitivity level.
Click on to apply the settings, or click on to disregard and return to Live mode. The live
monitoring screen will show the blue boxes.
- 63 -