PLANET WDAP-C7400 - Manual (Page 42)

User Manual of WDAP-C7400
-34-
5.4 Advanced
This section allows you to configure advanced settings, including RF Preamble, Beacon interval, Fragment
threshold, RTS threshold and DTIM interval, etc.
Figure 5-17 Advanced
The page includes the following fields:
Object Description
 RF Preamble:
A preamble is a signal used in network communications to synchronize
transmission timing between two or more systems
The default setting is Long.
 Beacon Interval:
A time interval between any 2 consecutive Beacon packets sent by
device.
Note: Do NOT change the default value of 100 unless necessary.
 Fragment
Threshold:
Enter a Fragment Threshold (256-2346). Any wireless packet exceeding
such set value will be divided into several fragments.
Note: DO NOT change the default value of 2346 unless necessary
 RTS Threshold:
If a packet exceeds such set value, RTS/CTS scheme will be used to
reduce collisions. Set it to a smaller value provided that there are distant
clients and interference.
For normal SOHO, it is recommended to keep the default value
unchanged; otherwise, device performance may be degraded
 DTIM Interval:
A time interval between any two consecutive broadcast and multicast
packet messages sent by the device to clients.
When such packets arrive at device’s buffer, the device will send DTIM
(delivery traffic indication message) and DTIM interval to wake
clients up for receiving these packets.
 TX Power
Percentage:
Set the wireless output power level. The default value is 100.