PLANET WDAP-C7400 - Manual (Page 19)

User Manual of WDAP-C7400
-11-
Chapter 3. Connecting to the AP
3.1 System Requirements
 Broadband Internet Access Service (Cable/xDSL/Ethernet connection)
 One IEEE 802.3at PoE Switch (supply power to the WDAP-C7400)
 PCs with a working Ethernet Adapter and an Ethernet cable with RJ-45 connectors
 PC of subscribers running Windows 98/ME, NT4.0, 2000/XP, Windows Vista / Win 7, MAC OS 9 or
later, Linux, UNIX or other platforms compatible with TCP/IP protocols
 The above PC is installed with WEB Browser
1. The AP in the following instructions means PLANET WDAP-C7400.
2. It is recommended to use Internet Explore 7.0 or above to access the AP.
3.2 Installing the AP
Before installing the AP, make sure your PoE Switch is connected to the Internet through the broadband service
successfully at this moment. If there is any problem, please contact your local ISP. After that, please install the
AP according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
Step 1. Plug the Ethernet cable into the PoE port.
Figure 3-1 WDAP-C7400 Installation Diagram-1
Step 2. Plug the other end of the Ethernet cable into the PoE switch.
※ IEEE 802.3at PoE switch is required.