PLANET IGT-902 - Manual (Page 16)

User’s Manual of IGT-90x
Step 3 : Use the screws to screw the wall mount plate on the Industrial Equipment.
Step 4 : Use the hook holes at the corners of the wall mount plate to hang the Industrial Equipment on the wall.
Step 5 : To remove the wall mount plate, reverse steps above.
2.2.3 Stand-alone Installation
IGT-902 / IGT-902T/ IGT-902S/ IGT-902TS Installation:
To install an Industrial Managed Media Converter stand-alone, on a Track or wall mount, simply complete the following
steps:
Step 1 : Turn off the DC power of the device/station in a network to which IGT-90X will be attached.
Step 2 : Ensure that there is no activity in the network.
Step 3 : Attach fiber cable from the Industrial Managed Media Converter to the fiber network. TX, RX must be paired at
both ends.
Step 4 : Connect the DC power to the IGT-90X and verify that the Power LED lights up.
Step 5 : Turn on the power of the device/station; the PWR LED (Green) should light when all cables are attached.
Figure 2-7 IGT- 902 / IGT-902T / IGT-902S / IGT-902TS stand-alone installation
-16-