PLANET IGT-902 - Manual (Page 12)

User’s Manual of IGT-90x
2.1.3 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial Media Converter is used for two DC redundant
powers input. Please follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for POWER 1, or 5 and 6 for POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
Power 1 Fault Power 2
- + - +
The wire gauge for the terminal block should be in the range between 12 ~ 24 AWG.
-12-