PLANET WGSD-10020 User Manual

Page 194

User’s Manual of WGSD-10020 Series

194

3. LLC

4. SNAP

5. IPv4

6. IPv6

Note: all frame types are explained below.

• Any

Allow all types of frames.

• Ethernet

Ethernet Type Valid ethernet type can have value within 0x600-0xFFFF or 'Any'

but excluding 0x800(IPv4) and 0x86DD(IPv6), default value is 'Any'.

• LLC

SSAP Address Valid SSAP(Source Service Access Point) can vary from 0x00 to

0xFF or 'Any', the default value is 'Any'

DSAP Address Valid DSAP(Destination Service Access Point) can vary from

0x00 to 0xFF or 'Any', the default value is 'Any'

Control Address Valid Control Address can vary from 0x00 to 0xFF or 'Any', the

default value is 'Any'

• SNAP

PID Valid PID(a.k.a ethernet type) can have value within 0x00-0xFFFF or 'Any',

default value is 'Any'

• IPv4

Protocol IP protocol number: (0-255, TCP or UDP) or 'Any'

Source IP Specific Source IP address in value/mask format or 'Any'. IP and Mask

are in the format x.y.z.w where x, y, z, and w are decimal numbers between 0 and

255. When Mask is converted to a 32-bit binary string and read from left to right,

all bits following the first zero must also be zero

DSCP Diffserv Code Point value(DSCP): It can be specific value, range of value

or 'Any'. DSCP values are in the range 0-63 including BE, CS1-CS7, EF or

AF11-AF43

IP Fragment IPv4 frame fragmented option: yes|no|any

Sport Source TCP/UDP port:(0-65535) or 'Any', specific or port range applicable

for IP protocol UDP/TCP

Dport Destination TCP/UDP port:(0-65535) or 'Any', specific or port range

applicable for IP protocol UDP/TCP

• IPv6