beautypg.com

PLANET FNSW-2402S User Manual

Page 8

background image

6

7

2.1.3 LED Indicators

LED

Color

Function

PWR

Green

Lit: Power on

LNK/ACT

Green

Lit: indicate the link through that port is successfully
established
Blink: indicate that the switch is actively sending or
receiving data over that port

100

Orange

Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps.

2.1.4 Extension Slots

The Switch extension slots #25 and #26 can be a 10/100Base-TX/FX switching port as
the extension module installed.

Please refer to the section 3.2.3.1 Port Configuration for the detailed installation and
settings.

2.1.5 FNSW-2402S Rear Panel

The rear panel of the Switch indicates an AC inlet power socket, which accepts input
power from 100 to 240VAC, 50-60Hz. Figure 2-2 shows Rear panel of FNSW-2402S.

Figure 2-2 Rear Panel of FNSW-2402S

Power Notice:

1.The device is a power-required device, it means, it will not work till it is

powered. If your networks should active all the time, please consider using
UPS (Uninterrupted Power Supply) for your device. It will prevent you from
network data loss or network downtime.

2.In some area, installing a surge suppression device may also help to protect

your switch from being damaged by unregulated surge or current to the
Switch or the power adapter.

2.2 Installing a FNSW-2402S

This part describes how to install your FNSW-2402S Smart Fast Ethernet Switch and make
connections to the switch. Please read the following topics and perform the procedures in
the order being presented.

To install your FNSW-2402S on a desktop or shelf, simply complete the following steps.