Avago Technologies LSI7104EP-LC - Manual (Page 64)

4-8 BIOS Features
Ver. 2.1 Copyright © 2005-2006 by LSI Logic Corporation. All rights reserved.
4.7.2 Identifying the FC Devices
The probe-scsi-all command identifies the FC devices on your
Fusion-MPT adapter.
To show all disks available from the OpenBoot prompt, use the
probe-scsi-all command. Note that this command is used regardless
of whether the disks are FC or SCSI. All disks available on all
Fusion-MPT devices are displayed.
The following example shows the kind of information that is displayed
when you enter this command.
ok probe-scsi-all
/pci@8,600000/SUNW,qlc@4
LiD HA LUN ---Port WWN--- ----Disk description----
1 1 0 2100002037e4d65b SEAGATE ST318304FSUN18G 0726
/pci@8,700000/IntraServer-Ultra160,scsi@3,1
/pci@8,700000/IntraServer-Ultra160,scsi@3
Target 0
Unit 0 Disk IBM DDRS-34560D DC1B
/pci@8,700000/IntraServer,fc@2
MPT Version 1.00, Firmware Version 1.02.00
Target 0
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 2100002037109d76 Port ID d9
Target 1
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 210000203710565a Port ID 17
Target 2
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 2100002037105212 Port ID 1
Target 3
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 2100002037103da8 Port ID 26