Avago Technologies LSI7104EP-LC - Manual (Page 27)

Operational Environment 2-7
Ver. 2.1 Copyright © 2005-2006 by LSI Logic Corporation. All rights reserved.
2.5.3 Electromagnetic Compliance
These boards are designed and implemented to minimize susceptibility
to electromagnetic emissions, and the effects of electromagnetic
discharge. All of these boards (except the LSI7404XP-LC) are tested to
comply with Class B and carry markings for CE, VCCI, Canada, C-Tick,
and the FCC.
Note: The LSI7404XP-LC is tested to comply with Class A and
carries markings for CE, VCCI, Canada, C-Tick, and the
FCC.
2.5.4 Safety Characteristics
The bare boards meet the requirements of flammability rating UL 94 V-0.
The bare boards are also marked with the supplier name or trademark,
type, and UL flammability rating. Because these boards are installed in
a PCI bus slot, all voltages are below the SELV 42.4 V limit.
2.6 Operational Environment
Use the LSI Logic 4 Gbit/s family of FC host adapters in PCI-X or
PCI Express computer systems with an Industry Standard
Architecture/Extended Industry Standard Architecture (ISA/EISA) bracket
type. The LSI Logic-supplied FC BIOS and firmware operate the host
adapters. An on-board flash memory device and a serial EEPROM are
provided to allow BIOS code and OpenBoot code support over the PCI
bus.
2.6.1 PCI-X Interface
The PCI-X interface operates as a 64-bit DMA bus master. The edge
connector makes the PCI-X connection, which provides connections on
both the front and back of the board. The signal definitions and pin
numbers conform to the PCI-X/133 Specification, Revision 1.0a. Refer to
that specification for details regarding the signal assignments.