Avago Technologies LSI7104EP-LC - Manual (Page 16)

1-2 Installation Procedures
Ver. 2.1 Copyright © 2005-2006 by LSI Logic Corporation. All rights reserved.
For specific information about the FC controllers, refer to LSIFC949X
Dual Channel Fibre Channel I/O Processor Technical Manual.
1.2 Quick Installation Procedure
This section provides an overview of the installation procedure. If you are
an experienced computer user with prior host adapter installation and FC
setup experience, this section may describe the procedure sufficiently. If
you prefer more detailed guidance for installing the host adapter, proceed
to
Section 1.3, “Detailed Installation Procedure.”
For safe and proper installation, refer to the user’s manual supplied with
your computer and perform the following steps:
Step 1. Ground yourself before removing this host adapter board.
Step 2. Remove the host adapter from the packaging and check that it
is not damaged.
Figure 1.1 on page 1-4 illustrates an example of this host
adapter board. Also refer to Chapter 2, “4 Gbit/s Host Adapter
Characteristics,” to see more detailed drawings of the 4 Gbit/s
host adapter boards.
Step 3. Open your PC cabinet and select an appropriate open PCI slot.
Step 4. Insert the host adapter board.
Step 5. Make any configuration changes.
Step 6. Close your PC cabinet cover.
Step 7. Connect the FC cable to the host adapter.
1.3 Detailed Installation Procedure
This section provides step-by-step instructions for installing the host
adapter. If you are experienced in these tasks, you may prefer to use
Section 1.2, “Quick Installation Procedure.”