Removing the raid controller from the computer – Avago Technologies MegaRAID SAS 9266-4i User Manual
Page 22
LSI Corporation
- 22 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Connecting the LSIiBBU09 Unit to the MegaRAID SAS 9266 RAID Controller
Connecting a Remote LSIiBBU09 Unit to the MegaRAID SAS 9266 RAID Controller
The procedures in this section show how to connect a remote LSIiBBU09 unit by cable to your MegaRAID SAS 9266
RAID controller. To connect a remote LSIiBBU09 unit to your RAID controller, perform the following tasks:
1.
Remove the RAID controller from the computer. See
Removing the RAID Controller from the Computer
2.
Connect the cable between the RAID controller and the remote LSIiBBU09 unit. See
Between the RAID Controller and the Remote LSIiBBU09 Unit
3.
Reinstall the RAID controller in the computer. See
Reinstalling the RAID Controller in the Computer
on page
Removing the RAID Controller from the Computer
Follow these steps to remove the RAID controller from the computer.
1.
Turn off the power, and unplug the power cords.
2.
Ground yourself, and make sure that the system is grounded.
3.
Remove the cover from the computer, according to the instructions in the system user’s manual, to allow access
to the controller.
4.
Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.
5.
Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
NOTE Because server and workstation chassis vary from vendor to vendor, no standard mounting option
exists that is compatible with the various system configurations. The LSIiBBU09 battery kit, in combination
with the Remote Battery Kit, includes the battery, daughtercard, cable, and standoff. This combination
enables authorized resellers and chassis manufacturers to customize the location of the remote battery to
provide the most flexibility within various environments. The BBU-BRACKET-05 remote mount board is an
option, because it has holes appropriate for mounting MegaRAID BBU units.