Removing the raid controller from the computer – Avago Technologies MegaRAID SAS 9266-4i User Manual
Page 11
LSI Corporation
- 11 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Attaching a CVFM02 Module Directly to the RAID Controller and Connecting to a CVPM02
Module on a Remote Mount Board
Attaching the CVFM02 Module Directly to the MegaRAID SAS 9266 RAID Controller
Perform the following tasks to attach the CVFM02 module directly to your MegaRAID SAS 9266 RAID controller.
1.
Remove the RAID controller from the computer. See
Removing the RAID Controller from the Computer
2.
Attach the CVFM02 module directly to the RAID controller. See
Attaching the CVFM02 Module Directly to the
Removing the RAID Controller from the Computer
Follow these steps to remove the RAID controller from the computer.
1.
Turn off the power, and unplug the power cords.
2.
Ground yourself, and make sure that the system is grounded.
3.
Remove the cover from the computer, according to the instructions in the system user’s manual, to allow access
to the controller.
4.
Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.
5.
Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
CAUTION Electrostatic discharge (ESD) can damage the CVFM02 module and the RAID controller. Make
sure that you install the CVFM02 module at an ESD-safe workstation that meets the EIA-625 standard.
When you install the CVFM02 module, follow the ESD-recommended practices in the latest revision of the
IPC-A-610 standard.