Avago Technologies MegaRAID SAS 9266-4i - Manual (Page 19)

LSI Corporation
- 19 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Connecting the LSIiBBU09 Unit to the MegaRAID SAS 9266 RAID Controller
Attaching the LSIiBBU09 Unit Directly to the MegaRAID SAS 9266 RAID Controller
Perform the following tasks described in this section to attach the LSIiBBU09 unit directly to the MegaRAID SAS 9266
RAID controller.
1. Remove the RAID controller from the computer. See Removing the RAID Controller from the Computer .
2. Attach the LSIiBBU09 unit directly to the RAID controller. See Attaching the LSIiBBU09 Unit to the RAID Controller
on page 20 .
3. Reinstall the RAID controller on the motherboard. See Reinstalling the RAID Controller on the Motherboard on
page 21 .
Removing the RAID Controller from the Computer
Follow these steps to remove the RAID controller from the computer.
1. Turn off the power, and unplug the power cords.
2. Ground yourself, and make sure that the system is grounded.
3. Remove the cover from the computer, according to the instructions in the system user’s manual, to allow access
to the controller.
4. Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.
5. Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
CAUTION Electrostatic discharge (ESD) can damage the LSIiBBU09 unit and the RAID controller. Make
sure that you install the LSIiBBU09 unit at an ESD-safe workstation that meets the EIA-625 standard. When
you install the LSIiBBU09 unit, follow the ESD-recommended practices in the latest revision of the
IPC-A-610 standard.