Avago Technologies MegaRAID SAS 9266-4i User Manual
Page 21
LSI Corporation
- 21 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Connecting the LSIiBBU09 Unit to the MegaRAID SAS 9266 RAID Controller
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on a motherboard.
1.
Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2.
Install the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.
3.
Press down gently, but firmly, to seat the card correctly in the slot.
4.
Secure the controller to the computer chassis.
Figure 13 Reinstalling the RAID Controller
5.
Replace the computer cover, and reattach the power cords.
6.
Turn on the power to the computer.
NOTE Some PCI Express slots support only PCI Express graphics cards. If a RAID controller is installed in
one of these slots, the controller will not function. Refer to your computer documentation for information
about the PCI Express slot.
Edge of
Motherboard
PCI Express
Bracket
Screw
Press
Here
Press
Here
3_00891a-00