Avago Technologies MegaRAID SAS 9266-4i - Manual (Page 20)

LSI Corporation
- 20 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Connecting the LSIiBBU09 Unit to the MegaRAID SAS 9266 RAID Controller
Attaching the LSIiBBU09 Unit to the RAID Controller
Follow these steps to attach the LSIiBBU09 unit directly to the front of the RAID controller.
1. Ground yourself, and make sure that the system is grounded.
2. Remove the LSIiBBU09 unit from the package.
3. Place the LSIiBBU09 unit front-side-up on a flat, clean, static-free surface.
4. Place the RAID controller front-side up on a flat, clean, static-free surface.
5. Hold the LSIiBBU09 unit so that the top of the battery is facing upward, and the J1 connector lines up with the
J1A3 BBU connector on the RAID controller, as shown in the following figure.
Figure 12 Attaching the LSIiBBU09 Unit to the RAID Controller
6. Carefully press the LSIiBBU09 unit onto the RAID controller so that the two connectors are firmly joined.
7. Secure the LSIiBBU09 unit to the RAID controller with the screws and the standoffs in the three screw holes.
The standoffs are threaded at both ends, and a screw goes into each end. The screw threads from the back of the
controller board into the board-to-board standoffs on the bottom of the LSIiBBU09 unit.
Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten the screws.
WARNING There is danger of an explosion if the battery is incorrectly replaced. Replace the battery only with
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
3_00896-00
J1A3
LSIiBBU09