Avago Technologies MegaRAID SAS 9266-4i - Manual (Page 12)

LSI Corporation
- 12 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Attaching a CVFM02 Module Directly to the RAID Controller and Connecting to a CVPM02
Module on a Remote Mount Board
Attaching the CVFM02 Module Directly to the RAID Controller
Follow these steps to attach the CVFM02 module to the front of the RAID controller.
1. Ground yourself, and make sure that the system is grounded.
2. Remove the CVFM02 module from the package.
3. Place the CVFM02 module front-side-up on a flat, clean, static-free surface.
4. Place the RAID controller on a flat, clean, static-free surface.
5. Hold the CVFM02 module so that the top side faces upward. Align the J3L1 connector on the CVFM02 module
with the J4B1 connector on the RAID controller, as shown in the following figure.
Figure 5 Attaching the CVFM02 Module Directly to the MegaRAID SAS 9266 RAID Controller
6. Carefully press the CVFM02 module onto the RAID controller so that the two connectors are firmly joined.
7. Secure the CVFM02 module to the RAID controller with the screws and the standoffs in the three screw holes.
The standoffs are threaded at both ends, and a screw goes into each end. The screw threads from the back of the
controller board into the board-to-board standoffs on the bottom of the CVFM02 module.
Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten the screws.
3_00893-00
J4B1
CacheVault
Flah Module