Avago Technologies MegaRAID SAS 9266-4i - Manual (Page 15)

LSI Corporation
- 15 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Attaching a CVFM02 Module Directly to the RAID Controller and Connecting to a CVPM02
Module on a Remote Mount Board
Connecting the CVFM02 Module to the Remote CVPM02 Module
Follow these steps to connect the CVFM02 module on your MegaRAID SAS 9266 RAID controller by cable to the
remote CVPM02 module.
1. Place the controller on a flat, clean, static-free surface.
2. Ground yourself, and make sure that the system is grounded.
3. Remove the cable included in the RAID controller box.
4. Insert the smaller of the two 6-pin cable connectors on the cable into the 6-pin J2B1 cable connector on the
CVFM02 module, as shown in the following figure.
5. Insert the larger of the two 6-pin cable connectors on the other end of the cable into the 6-pin cable connector on
the remote CVPM02 module.
Align the cable connectors to make sure that they are connected correctly.
Figure 8 Connecting the CVFM02 Module on the RAID Controller to the Remote CVPM02 Module
3_00894-00
J2B1