Avago Technologies MegaRAID SAS 9266-4i - Manual (Page 16)

LSI Corporation
- 16 -
MegaRAID SAS 9266-4i and SAS 9266-8i RAID Controllers Quick Installation Guide
July 2012
Attaching a CVFM02 Module Directly to the RAID Controller and Connecting to a CVPM02
Module on a Remote Mount Board
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall your MegaRAID 9266 RAID controller on the motherboard.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Install the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the card correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 9 Reinstalling the RAID Controller
NOTE Some PCI Express slots support PCI Express graphics cards only. If a RAID controller is installed in
one of these slots, the controller will not function. Refer to your computer documentation for information
about the PCI Express slot.
Edge of
Motherboard
PCI Express
Bracket
Screw
Press
Here
Press
Here
3_00899-00