Avago Technologies MegaRAID SAS 9260-4i - Manual (Page 7)

LSI Corporation
- 7 -
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
October 2011 MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
Installing a LSIiBBU07 Unit Directly on a MegaRAID SAS RAID Controller
Reinstalling the RAID Controller
Follow these steps to reinstall the RAID controller on the motherboard.
1. With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the RAID controller in a PCI Express® slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the card correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 3 Reinstalling the RAID Controller
5. Attach the cables from the external port connectors to the drives.
6. Replace the computer cover, and reattach the power cords.
7. Turn on the power to the computer.
NOTE Some PCI Express slots support only PCI Express graphics cards; if a RAID controller is installed in
one of these slots, it will not function. Refer to your computer documentation for information about the
PCI Express slot.
Edge of Motherboard
LSIiBBU07 (Top View)
Bracket Screw
Edge of
Motherboard
Press Here
85021-04
Press Here