Avago Technologies MegaRAID SAS 9260-4i User Manual
Page 10
LSI Corporation
- 10 -
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
October 2011
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
Connecting a Remote LSIiBBU07 Unit to the BBU Connector on the RAID Controller
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on a motherboard.
1.
With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2.
Insert the RAID controller in a PCI Express slot on the motherboard, as shown in the following figure.
3.
Press down gently, but firmly, to seat the card correctly in the slot.
4.
Secure the controller to the computer chassis with the bracket screw.
Figure 5 Reinstalling the RAID Controller
5.
Replace the computer cover, and reattach the power cords.
6.
Turn on the power to the computer.
NOTE Some PCI Express slots support only PCI Express graphics cards; if a RAID controller is installed in
one of these slots, it will not function. Refer to your computer documentation for information about the
PCI Express slot.
3_00861-00
1
2
2
Edge of
Motherboard
Edge of
Motherboard