Removing the raid controller from the computer – Avago Technologies MegaRAID SAS 9260-4i User Manual
Page 15
LSI Corporation
- 15 -
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
October 2011
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
Connecting an LSIiBBU07 Unit from a Remote Mount Board to a Board-to-Board Adapter
Card on a RAID Controller
Connecting an LSIiBBU07 Unit from a Remote Mount Board to a Board-to-Board
Adapter Card on a RAID Controller
This section describes how to connect an LSIiBBU07 unit on a remote mount board by cable to a board-to-board
adapter card on your RAID controller. This procedure shows the SAS 8880EM2 RAID controller; you can connect the
LSIiBBU07 unit in the same way to the other MegaRAID controllers that support this method of connection
Perform the following tasks:
1.
Remove the RAID controller from the computer. For this procedure, see
Removing the RAID Controller from the
.
2.
Install the board-to-board adapter card on the RAID controller. For this procedure, see
Board-to-Board Cable Adapter Card on the RAID Controller
3.
Connect the cable between the board-to-board adapter card on the RAID controller and the LSIiBBU07 unit on
the system chassis. For this procedure, see
Connecting the LSIiBBU07 Unit on the Remote Mount Board to the
Board-to Board Cable Adapter Card on the RAID Controller
on page
4.
Reinstall the RAID controller. For this procedure, see
Reinstalling the RAID Controller
.
5.
Install the remote mount board. For this procedure, see
Installing the Remote Mount Board
on page
Removing the RAID Controller from the Computer
Follow these steps to remove the RAID controller from the computer.
1.
Turn off the power, and unplug the power cords.
2.
Ground yourself, and make sure that the system is grounded.
3.
Remove the cover from the computer, using the instructions in the system user’s manual, to allow access to
the controller.
4.
Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.
5.
Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
NOTE The remote mount board can hold up to two LSIiBBU07 units. The procedure in this section shows the
remote mount board with one LSIiBBU07 unit.
WARNING Ground yourself, and disconnect the power cords from the system before you remove the cover.
Also, make sure that the system is grounded.