Avago Technologies MegaRAID SAS 9260-4i - Manual (Page 4)

LSI Corporation
- 4 -
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
October 2011 MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
Front View and Rear View of the LSIiBBU07 Unit
— MegaRAID SAS 9280-8e
— MegaRAID SAS 9280DE-8e
 Mode 4: Connect a 12-in. cable between a LSIiBBU07 unit on a remote mount board and a board-to-board cable
adapter card on the RAID controller. Reinstall the RAID controller, and then install the remote mount board. Use
this mode with the following MegaRAID SAS RAID controllers:
— MegaRAID SAS 8880EM2
— MegaRAID SAS 9260-4i
— MegaRAID SAS 9260-8i
— MegaRAID SAS 9261-8i
— MegaRAID SAS 9280-4i4e
— MegaRAID SAS 9280-8e
Front View and Rear View of the LSIiBBU07 Unit
The following figure shows the front view and the rear view of the LSIiBBU07 unit. The front view is the side that you
can see after you install the LSIiBBU07 unit on the RAID controller. Note that the LSIiBBU07 unit combines a battery
pack with a daughter card. The unit uses screws and standoffs to connect to the RAID controller.
Figure 1 Front View and Rear View of the LSIiBBU07 Unit
1. J4 Battery Pack harness Connector
2. J5 Board-to-Board Connector
WARNING The battery used in this device might present a fire or chemical burn hazard if mistreated. Do not
disassemble, heat above 100 °C, or incinerate. Dispose of used battery properly. Keep away from children.
85021-05
(Rear View)
(Front View)
J4
J5
J2
4
1
2
3
4