Avago Technologies MegaRAID SAS 9260-4i - Manual (Page 19)

LSI Corporation
- 19 -
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
October 2011 MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
Connecting an LSIiBBU07 Unit from a Remote Mount Board to a Board-to-Board Adapter
Card on a RAID Controller
Installing the Remote Mount Board
Follow these steps to install the remote mount board in the computer.
1. With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCI Express slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the board correctly in the slot.
Figure 12 Installing the Remote Mount Board
4. Secure the remote mount board to the computer chassis with the bracket screw.
5. Attach the cables from the external port connectors to the drives.
6. Reinstall the computer cover, and reattach the power cords.
7. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information about running the RAID configuration utility and
installing the software drivers.
NOTE Some PCI Express slots support only PCI Express graphics cards; if a RAID controller is installed in
one of these slots, the controller does not function. Refer to your computer documentation for
information about the PCI Express slot.
Screw
Press
Here
Press
Here
3_00722-00