Avago Technologies MegaRAID SAS 9260-4i - Manual (Page 18)

LSI Corporation
- 18 -
MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
October 2011 MegaRAID LSIiBBU07 Intelligent Battery Backup Unit Quick Installation Guide
Connecting an LSIiBBU07 Unit from a Remote Mount Board to a Board-to-Board Adapter
Card on a RAID Controller
Reinstalling the RAID Controller
Follow these steps to reinstall the RAID controller in the computer.
1. With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the RAID controller into a PCI Express slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the controller correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 11 Reinstalling the RAID Controller
NOTE Some PCI Express slots support only PCI Express graphics cards; if a RAID controller is installed in
one of these slots, the controller does not function. Refer to your computer documentation for
information about the PCI Express slot.
Edge of Motherboard
Press
Here
3_00721-00
Screw
Press
Here