Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 9)

LSI Corporation | July 2010 Page 9
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide Connecting the LSIiBBU07 Remotely to the MegaRAID SAS RAID Controller
NOTE: Some PCI Express slots support only PCI Express graphics cards; if a RAID
controller is installed in one of these slots, it does not function. Refer to your computer
documentation for information about the PCI Express slot.
Figure 5: Installing the MegaRAID SAS 8880EM2 Controller
8. Press down gently but firmly to seat the card correctly in the slot.
9. Secure the controller to the computer chassis with the bracket screw.
10. Reinstall the computer cover and reattach the power cords.
11. Turn on the power to the computer.
3.2 Connecting the Remote
LSIiBBU07 to the Interposer Card on the
RAID Controller
To connect the remote LSIiBBU07 to a interposer card on the RAID controller, perform
the following tasks in order.
1. Install the interposer card on the RAID controller.
2. Mount the LSIiBBU07 to the chassis.
3. Connect the controller to the remote LSIiBBU07 using the 27-inch, 20-pin cable and
the interposer.
4. Install the controller.
Because server and workstation chassis vary from vendor to vendor, no standard
mounting option is compatible with the various system configurations. Therefore, the
LSIiBBU07 battery kit contains only the battery, interposer card, and standoff, which
enables authorized resellers and chassis manufacturers to customize the location of the
remote battery to provide the most flexibility within various environments.
Edge of Motherboard
Bracket Screw
Edge of
Motherboard
Press Here
85021-16
Press Here