Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 6)

Page 6 LSI Corporation | July 2010
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide
Connecting the LSIiBBU06 Remotely to the MegaRAID SAS RAID Controller
Figure 2: Connecting the LSIiBBU06 Remotely to the MegaRAID SAS Controller
Follow these steps to install the RAID controller in the computer.
NOTE: Some PCI Express slots support only PCI Express graphics cards; if a RAID
controller is installed in one of these slots, it does not function. Refer to your computer
documentation for information about the PCI Express slot.
1. Turn off the power to the computer, and disconnect the AC power cord.
2. Remove the computer cover.
Refer to the system documentation for instructions. Before you install the controller,
make sure that the computer is disconnected from the power and from any networks.
3. Select a PCI Express slot on the motherboard, align the controller’s PCI Express bus
connector to the slot, and then insert the RAID controller in the slot, as shown in the
following figure.
85024-07