Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 11)

LSI Corporation | July 2010 Page 11
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide Connecting the LSIiBBU07 Remotely to the MegaRAID SAS RAID Controller
Follow these steps to connect the cable between the interposer card and the LSIiBBU07.
1. Mount the LSIiBBU07 to the chassis of your computer based on the location and the
type of mounting option.
2. Make sure you are grounded and then remove the 27-inch cable from the remote
kit package.
3. Insert one end of the cable into the 20-pin J2 connector on the LSIiBBU07 and the
other end into the 20-pin J1 connector on the interposer card, as shown in Figure 7 .
Align the black triangles on the connectors to make sure they are connected properly.
NOTE: The cable connectors are polarized and can be inserted into the connectors on
the interposer card and the LSIiBBU07 only if the rails on the cable connectors align with
the slots on the other connectors. Do not force the cable into the 20-pin connectors. The
cable end inserts into the connector with minimal resistance.
Figure 7: Connecting the LSIiBBU07 Remotely to the MegaRAID SAS Controller
Follow these steps to install the controller in the computer.
NOTE: Some PCI Express slots support only PCI Express graphics cards; if a RAID
controller is installed in one of these slots, it does not function. Refer to your computer
documentation for information about the PCI Express slot.
1. Turn off the power to the computer, and disconnect the AC power cord.
2. Remove the computer cover.
Refer to the system documentation for instructions. Before you install the controller,
make sure that the computer is disconnected from the power and from any networks.
3. Select a PCI Express slot on the motherboard, align the controller’s PCI Express
bus connector to the slot, and then insert the RAID controller in the slot, as shown
in
Figure 8 .
85021-13