Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 5)

LSI Corporation | July 2010 Page 5
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide Connecting the LSIiBBU06 Remotely to the MegaRAID SAS RAID Controller
4. Hold the interposer card so that the J2 board-to-board connector on the interposer
card lines up with the J1 board-to-board connector on the RAID controller.
5. Carefully press the J2 connector on the interposer card into the J1 connector on the
RAID controller so that the two connectors are firmly joined.
The connectors fit only when they are in correct alignment.
6. Use the other screw to secure the interposer card to the controller and continue
with the next procedure.
Figure 1: Connecting the Interposer Card to the RAID Controller
Follow these steps to connect the cable between the interposer card and the LSIiBBU06.
1. Mount the LSIiBBU06 to the chassis of your computer based on the location and the
type of mounting option.
2. Make sure you are grounded and then remove the 27-inch cable from the remote
kit package.
3. Insert one end of the cable into the 20-pin J2 connector on the LSIiBBU06 and the
other end into the 20-pin J1 connector on the interposer card, as shown in Figure 2 .
Align the black triangles on the connectors to make sure they are connected properly.
NOTE: The cable connectors are polarized and can be inserted into the connectors on
the interposer card and the LSIiBBU06 only if the rails on the cable connectors align with
the slots on the other connectors. Do not force the cable into the 20-pin connectors. The
cable end inserts into the connector with minimal resistance.
85024-06