Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 7)

LSI Corporation | July 2010 Page 7
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide Connecting the LSIiBBU07 Remotely to the MegaRAID SAS RAID Controller
Figure 3: Installing the MegaRAID SAS Controller
4. Press down gently but firmly to seat the card correctly in the slot.
5. Secure the controller to the computer chassis with the bracket screw.
6. Reinstall the computer cover and reattach the power cords.
7. Turn on the power to the computer.
NOTE: Refer to the MegaRAID SAS Software User’s Guide for information about running
the RAID configuration utility and installing software drivers.
3.0 Connecting the
LSIiBBU07 Remotely to the
MegaRAID SAS RAID Controller
The procedures in this section show how to connect the LSIiBBU07 to the MegaRAID
8880EM2 RAID controller remotely. You can connect the LSIiBBU07 remotely to other
MegaRAID SAS RAID controllers in the same way. For information about which
controllers use the LSIiBBU07, see
Table 1 . For information about the BBU connectors
on these controllers, see the MegaRAID 1078-Based SAS RAID Controllers User Guide or
the MegaRAID 6Gb/s SAS RAID Controllers User Guide.
This section describes the two methods you can use to connect the LSIiBB07 remotely
to your SAS RAID controller using the supplied 12-inch, 20-pin cable:
 Use the cable to connect the remote LSIiBBU07 to the BBU connector on the
RAID controller.
 Use the cable to connect the remote LSIiBBU07 to an interposer card that is
connected to the RAID controller.
Edge of
Motherboard
Press Here
85024-08
Press Here
Edge of Motherboard
Bracket Screw