Avago Technologies MegaRAID SAS 9260-16i User Manual
Page 4
Page 4
LSI Corporation
|
July 2010
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide
Connecting the LSIiBBU06 Remotely to the MegaRAID SAS RAID Controller
2.0 Connecting
the
LSIiBBU06 Remotely to the
MegaRAID SAS RAID Controller
The procedures in this section show how to connect the LSIiBBU06 to the MegaRAID
SAS 8704EM2 and 8708EM2 RAID controllers remotely.
To connect the LSIiBBU06 remotely to the MegaRAID SAS 8704EM2 and the MegaRAID
SAS 8708EM2 RAID controllers, you must use the supplied interposer card. To connect
the LSIiBBU06 to the interposer card on the RAID controller, perform the following tasks
in order.
1. Install the interposer card on the RAID controller.
2. Mount the LSIiBBU06 to the chassis.
3. Connect the controller to the LSIiBBU06 using the 27-inch, 20-pin cable and
the interposer.
4. Install the controller.
Because server and workstation chassis vary from vendor to vendor, no standard
mounting option is compatible with the various system configurations. Therefore, the
LSIiBBU06 battery kit contains only the battery, interposer card, and standoff, which
enables authorized resellers and chassis manufacturers to customize the location of the
remote battery to provide the most flexibility within various environments.
Follow these steps to install the interposer card on the RAID controller as shown in
1. With the controller on a flat, clean, static-free surface, ground yourself. Remove the
interposer card, standoff, and screws from the remote kit package.
2. Place the standoff on the controller so that the bottom side is over the screw hole
next to the J1 connector on the controller.
3. Use one of the screws to secure the standoff to the controller.
NOTE: Center the screwdriver carefully to avoid stripping the screw head. Do not
overtighten the screws.
MegaRAID SAS 9260-4i
x
x
MegaRAID SAS 9260-8i
x
x
MegaRAID SAS 9260-16i
x
(remote only)
x
(remote only)
MegaRAID SAS 9261-8i
x
x
MegaRAID SAS 9280-4i4e
x
x
MegaRAID SAS 9280-8e
x
x
MegaRAID SAS 9280-16i4e
x
(remote only)
x
(remote only)
MegaRAID SAS 9280-24i4e
x
(remote only)
x
(remote only)
Table 1:
MegaRAID Battery Backup Units and Compatible RAID Controllers (Continued)
Controller
LSIiBBU06
LSIiBBU07
LSIiBBU08