Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 10)

Page 10 LSI Corporation | July 2010
MegaRAID Remote Kit for the LSIiBBU06, LSIiBBU07, and LSIiBBU08 Intelligent Battery
Backup Units Quick Installation Guide
Connecting the LSIiBBU07 Remotely to the MegaRAID SAS RAID Controller
Follow these steps to install the interposer card on the RAID controller, as shown in
Figure 6 .
1. With the controller on a flat, clean, static-free surface, ground yourself. Remove the
interposer card, standoff, and screws from the package.
2. Place the standoff on the controller so that the bottom side is over the screw hole
next to the J1 connector on the controller.
3. Use one of the screws to secure the standoff to the controller.
CAUTION: Center the screwdriver carefully to avoid stripping the screw head. Do not
overtighten the screws.
4. Hold the interposer card so that the J2 board-to-board connector on the interposer
card lines up with the J1 board-to-board connector on the controller.
5. Carefully press the J2 connector on the interposer card into the J1 connector on the
controller so that the two connectors are firmly joined.
The connectors fit only when they are in the correct alignment.
6. Use the other screw to secure the interposer card to the controller and continue
with the next procedure.
Figure 6: Connecting the Interposer Card to the RAID Controller