Amprobe Multitest-1000 Continuity-Tester - Manual (Page 30)

)
ν ph
If two measurement cables were
connected to the same phase
conductor, when START/STOP is
pressed the instrument displays the
message alongside.
Message “PH
double”: two
cables are
connected to the
same phase
conductor.
SAVE THE PREVIOUS RESULTS CANNOT BE SAVED.
)
0
V
0
V
388
V
If one cable is not connected to the
network or one phase is absent, the
instrument displays the screen
alongside
Black cable= L1
is not connected
to one phase of
the installation.
Voltage between
phase L2 and
phase L3 is not
null (L2- L3).
Black cable=L1 is not connected to one phase of
the installation. Voltage between phase L1 and
phase L2 is null (L1-L2).
Black cable=L1 is not connected to one phase of
the installation. Voltage between phase L3 and
phase L1 is null (L3 - L1).
)
0
V
0
V
0
V
If two or more cables of the instrument
are not connected, it displays the screen
alongside.
SAVE SAVING: The tests can be stored pressing the SAVE key twice (refer
to paragraph 5.1).