Amprobe DMIII-Multitest Power-Quality-Recorder - Manual (Page 69)

AMPROBE
DMIII MULTITEST
EN-67
9. SAVING RESULTS
The SAVE button can be used to store the displayed results related to the rotary switch
position:
 SAFETY TEST (LOW

, Insulation Test, Phase sequence, Ground Test): pressing this
key the instrument will store the displayed result generating a corresponding record in
the SAFETY TEST MEMORY (see paragraph 11.1)
 POWER QUALITY: pressing this key the instrument will store the displayed result
generating a "Smp" record in the ANALYZER MEMORY (see paragraph 11.2)
Please note that Saving results is different from recording.
9.1.
SAVING SAFETY TEST RESULTS
After a SAFETY TEST (LOW

, Insulation Test, Phase sequence, Ground Test) the user
can press the SAVE button to store the displayed result.
 The
REMINDER
PLACE parameter
isn't related to
Measurement Order
Number
and can
help the user to
remind
the place
where he performed
the measurement.
05.06.01
SAVE IN LOC. 006
OK? (SAVE/ESC)
REMINDER PLACE:009
Memory Location
REMINDER PARAMETER
 
The following keys are available:
 F3, F4: to adjust the REMINDER PLACE.
 SAVE:
to store the test result associating to the actual REMINDER PLACE
 ESC: to quit this mode without saving.
9.2.
SAVING DISPLAYED VALUES OF POWER QUALITY FUNCTION
During a Real Time measurement (in POWER QUALITY function) if the user press the
SAVE button, a "Smp" record will be generate in the "ANALYZER MEMORY". This file
contains the Voltage and Current values present at instrument's input when the user
pressed the SAVE key.
Downloading these values to a PC (using the management Software) the Power, Energy,
Harmonics, etc values can be calculated and displayed as well.