Amprobe DMIII-Multitest Power-Quality-Recorder - Manual (Page 21)

AMPROBE
DMIII MULTITEST
EN-19
6.1.5. "AUTO", RT+", "RT-" faulty cases
 If the instrument detect
the External Power
supply adapter
connected to instrument
will show the message
displayed to the right.
LOW  05.06.01
-
.- -

R+ R-
---  --- 
---mA ---mA
 REMOVE POWER
AUTO 0.11

Disconnect the External
Power Supply Adapter
FUNC CAL
 If the terminal voltage is
higher than 15V, the
instrument
does not
perform the test and
displays the screen to
the right for 5 seconds.
LOW  05.06.01
-.- -

R+ R-
-.--  -.-- 
---mA ---mA
 VOLT IN INPUT
AUTO 0.11 
ATTENTION: the test was
not performed because of
voltage at the terminal
ends.
FUNC CAL
 In the case that:
R
CALIBRATION
>R
MEASURED
the instrument displays
the screen to the right.
LOW  05.06.01

0.00

R+ R-
0.00  0.00 
219mA 219mA
CAL > RES
AUTO 0.11 
ATTENTION:
R
CALIBRATION
>R
MEASURED
FUNC CAL