Epson WorkForce C362B - Manual (Page 47)

Replacing Ink Cartridges 47
4. Before you open the new cartridge package, shake it four or five times. Then
remove it from the package.
Caution:
Do not touch the green chip on the front of the cartridge.
This can damage the ink cartridge.
5. Remove the yellow tape from the bottom of the ink
cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
6. Insert the new ink cartridge into the holder and push
it down until it clicks into place.
7. Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8. Close the scanner.
9. Press
OK
to begin charging the ink. This takes about 2 minutes. When you
see a completion message on the display screen, ink charging is finished.
Caution:
Never turn off the WorkForce 310 Series while ink is charging, or you’ll waste ink. If you
see an ink replacement message on the display screen, press OK, then press down all
the cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
WF310_QG.book Page 47 Wednesday, April 8, 2009 2:14 PM