Using emp monitor, Opening and closing emp monitor – Epson 6100i User Manual

Page 76

Managing the Projector from a Remote Computer

4. If your network assigns addresses automatically, turn on the

DHCP

setting.

5. If your network does not assign addresses automatically, turn off

DHCP

and enter the projector’s

IP Address

Subnet Mask

Gateway Address

, and

MAC Address

, as needed.

To enter numbers, use the

pointer button on the remote

control to highlight the number you want to input, then press the

Enter

button. When you’re finished changing an address in the

network menu, highlight

Finish

, then press the

Enter

button.

6. When you’re done making all necessary changes, press

exit the menu system.

Using EMP Monitor

EMP Monitor lets you manage all your projectors using a remote
computer. This lets you easily turn the projectors on or off (together
or individually), switch image sources, and check on their status.

Before using EMP Monitor, make sure you’ve installed the software as
described on page 74. The computer you’re using to monitor the
projector should already be connected to your network.

Opening and Closing EMP Monitor

To start EMP Monitor,

click

Start > Programs

All Programs >

EPSON Projector > EMP Monitor

If you’ve added the program to the Startup programs folder (see
page 84), then it may already be open. If so, click the icon in the
system tray on the lower-right corner of your screen to display the
EMP Monitor window:

To close EMP Monitor, select

Exit

from the File menu or right-click

the program icon shown above, then select

Exit

note

If you’re a network
administrator, you can use
the

SNMP

option to enter a

trap IP address. This lets you
receive trap alerts for the
projectors you’re monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with your dealer or
Epson for availability (see
page 109).

Click here to start EMP Monitor