6 3dnr, 7 special, 1 cam title – EverFocus EZ650 User Manual
Page 33
32
Press “RET” to save all settings in the DAY/NIGHT menu and returns to the
previous menu.
Press “END” to save all the setting menus and exit.
COLOR
The picture is always displayed in color, even at low light levels.
NOTE: In “color” operation, there is an IR “cut” (blocking) filter between the
lens and the sensor; thus EZ650 camera has very little IR sensitivity when
the image is displayed in color.
AUTO
The picture switches to color in a normal (bright) environment and switches
to B/W when the ambient illumination is low. The switching point is controlled
by the video signal level.
Note:
AGC selection must be set as middle or high in order to employ the
auto switching function.
Delay
Delay time for switch reaction on light changes, range 0~63 seconds.
S-Level
Trigger level for switching to day mode in range 0~100.
E-Level
Trigger level for switching to night mode in range 0~100.
NOTE: The AUTO mode is not recommended for applications with high-
power IR illumination. The camera may switch continuously between
Day and Night mode.
EXT
The picture will switch automatically to color in a normal environment and to
B/W when the ambient illumination is low based on the illumination reaching
the light sensor at the front of the camera body.
3.3.6 3DNR
3DNR reduces the background noise in a low luminance environment.
OFF Disables 3DNR to keep the same amount of noise.
ON
Enables 3DNR to reduce the noise. (default)
Level Noise reduction level from 0~100 while observing a low light image until the desired
image is achieved. (default=30)
Press “RET” to saves all settings in DNR menu and returns to the previous menu.
Press “END” to save all the setting menus and exit.
3.3.7 SPECIAL
In this section, user can do special settings including camera title, digital effects, motion, privacy
zones, synchronization and language.
Please direct the arrow to point to “SPECIAL” on the SETUP menu by using the UP and DOWN
buttons.
Select the mode you would like to operate by pressing the LEFT or RIGHT button.
3.3.7.1 CAM TITLE
Input the camera title, and it will be appeared on the monitor.