EverFocus EZ650 - Manual (Page 31)

30
1. Please direct the arrow to point to “BLC” by using the UP and DOWN buttons.
2. Select the HSBLC mode by pressing the LEFT or RIGHT button. Then make adjustments as
below:
LEVEL
Adjust the sensitivity level for HSBLC from 0 to 8.
DEFAULT Set the factory default values for HSBLC.
LEFT/RIGHT Set the Left/Right side of an area for the HSBLC to be adjusted. The value
adjustable is 0~6.
WIDTH Set the width of an area for the HSBLC to be adjusted. The value adjustable is
0~6.
TOP/BOTTOM Set the Top/Bottom side of an area for the HSBLC to be adjusted. The value
adjustable is 0~6.
HEIGHT Set the height of an area for the HSBLC to be adjusted. The value adjustable
is 0~6.
RETURN Press “RET” to save all settings in the HSBLC menu and return to the previous
menu.
Press “END” to save all the menu settings and exit.
3.3.3.5 D-WDR
When there are both bright and dark areas in the field of view at same time, this function can
help to even the exposure between these areas.
1.
Please direct the arrow to point to “D-WDR” by using the UP and DOWN buttons.
2. Select the mode you would like to operate by moving the joystick LEFT or RIGHT.
OFF Disables D-WDR function (default)
INDOOR Select this option if you are in an indoor environment.
OUTDOOR Select this option if you are in an outdoor environment.
RETURN Press “RET” to save all settings in the Exposure menu and return to the
previous menu.
Press “END” to save all the menu settings and exit.