Purdy AND6BC - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] 7/17/09
www.purdyelectronics.com
AND6BC
Ultra Bright LED Lamps
Weight: 2.0 mg Unit: mm
AND6BC
InGaN Ultra Bright Blue TOP LEDs
Features
• P-LCC-2 package with optical indicator
• Compatible with automatic placement equipment
• Suitable for infrared reflow, vapor phase reflow, and
wave solder processes
• Wide viewing angle
• Low (2mA) current operation
• Inter reflector
• Ideal for (LCD) backlight and pipe applications
• Pb-Free, RoHS
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
30 mA
Reverse Voltage V
R
5 V
Power Dissipation P
D 130 mW
Operating Temp. Range T
Opr -40 to 85 °C
Storage Temp. Range T
Stg -40 to 100 °C
Electrostatic Discharge ESD 1000 V
Peak Forward Current
(Duty 1/10 @ 1Khz)
IFP 100 mA
Precaution
Please be careful of the following:
1. Manual soldering: maximum temperature of iron tip: 260°C max.
Soldering time: within 5 sec. per solder-land
Soldering portion of lead: up to 1.6 mm from the body of the device
2. Reflow solder: recommended condition is as follows:
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA 2.7 3.2 3.7 V
Reverse Current I
R
V
R
= 5 V – – 50 µA
Luminous Intensity I
V
I
F
= 20 mA 72 80 90 mcd
Peak Emission Wavelength l
P
I
F
= 20 mA – 468 – nm
Spectral Line Half Width ∆l I
F
= 20 mA – 26 – nm
Dominant Wavelength ld I
F
= 20 mA 461.5 – 479.5 nm
Full Viewing Angle 2 θ 1/2 I
F
= 20 mA – 120 – degree
more than 2 min.
230 °C max.
140 - 160 °C
Temperature
10 sec. max.
Time
4 °C/sec.
max.
3. Absolute secure counter measures against
static electricity and surge should be taken
when handling these proucts. It is
recommended to use wrist band or antistatic
gloves when handling these LEDs.
Product specifications contained herein may be changed
without prior notice. It is therefore advisable to contact
Purdy Electronics before proceeding with the design of
equipment incorporating this product.
• RoHS Compliant