Purdy AND4YA - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 7/18/07
AND4YA
Ultra Bright LED Lamps: Type 2
Weight: 2.0 mg Unit: mm
1.25
2.0
Cathode
Index
Polarity
1.1
0.6
1.4
0.4
±
0.2
AND4YA
InGaAlP Ultra Bright Yellow Light Emission
Surface Mount Package
Features
• Small package size
• 2.0 (l) x 1.25 (w) x 1.1 (h) size
• Suitable for DIP and REFLOW soldering
• Recommended Forward Current: 10 mA
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
25 mA
Reverse Voltage V
R
5 V
Power Dissipation P
D
70 mW
Operating Temperature Range T
Opr
-40 to 85 °C
Storage Temperature Range T
Stg
-40 to 90 °C
Precaution
Please be careful of the following:
1. Manual soldering: maximum temperature of iron tip: 260°C max.
Soldering time: within 5 sec. per solder-land
Soldering portion of lead: up to 1.6 mm from the body of the device
2. Reflow solder: recommended condition is as follows:
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 2.1 2.4 V
Reverse Current I
R
V
R
= 5 V – – 10 µA
Luminous Intensity I
V
I
F
= 20 mA 58 80 – mcd
Peak Emission Wavelength l
P
I
F
= 20 mA – 591 – nm
Spectral Line Half Width ∆ λ I
F
= 20 mA – 15 – nm
Dominant Wavelength λ d I
F
= 20 mA – 589 – nm
Full Viewing Angle θ I
V
= 1/2 Peak – 140 – degree
more than 2 min.
230 °C max.
140 - 160 °C
Temperature
10 sec. max.
Time
4 °C/sec.
max.
1.2
1.2 0.9 1.2
Reflow
The following soldering patterns are
recommended for reflow and dip soldering
Product specifications contained herein may be
changed without prior notice. It is therefore
advisable to contact Purdy Electronics before
proceeding with the design of equipment
incorporating this product.
• RoHS Compliant